Replacement Closet Door Finger Pull

Just a simple fix to replace missing sliding closet door handles (I believe this is the one). I used this as a base to design a more custom door pull to use on the closet doors in my home (which I'll be uploading to Printables in the near future). There are 2 versions includedThe tall one was sized to fit some of the deeper holes that were already in the doors. The short one is sized more similarly to the original (2mm shorter than the tall version). On the front they both look the same though. I intentionally made the outermost diameter bigger than the original to conceal some of the blemishes around the door hole. PrintingI've uploaded a Bambu Studio print profile to MakerWorld, which has been tested and works. I used Bambu PLA Basic (Black). I printed it with 0.08mm layer height, and with supports under the lip. There's also versions that are flipped and can be printed with no supports at all (see comparison photos below). You may need a brim to aid in adhesion if you do that, and t