Thingiverse
Replacement pole holder for play tent
door toybuilder
260
Downloads
333
Likes
0
Makes
3-way pole holder for play tent with 11mm ID for receiving the pole.
You can scale up/down for different diameter pole, of course.
Design for low-duty use for a play tent, but made thicker than the original part (shown in photo), so it should hold up well enough. You can always reprint more! :)
Two corners are 80.5 degrees, and third corner is 86.5 degrees. This allows for slight tensioning of the poles to retain the holders during use.
You can scale up/down for different diameter pole, of course.
Design for low-duty use for a play tent, but made thicker than the original part (shown in photo), so it should hold up well enough. You can always reprint more! :)
Two corners are 80.5 degrees, and third corner is 86.5 degrees. This allows for slight tensioning of the poles to retain the holders during use.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
