Replacement Rack Ears (Mounts) for Behringer Devices

Replacement rack mounts for some Behringer rackmountable devices
Had to make ears for an earless 1U Behringer device I had. Also made 2U because why not

1U fits Composer Pro-XL MDX2600 and Powerplay Pro-XL HA4700
2U fits Ultragraph Pro FBQ3102

Likely they fit some other Behringer devices, these are the ones I was able to test fit the mounts on

I recommend printing with 3 or more walls (assuming 0.4 mm nozzle) and no infill. Small holes don't really need supports, but the rack holes and the inside ‘bump’ might, depending on your filament choice and printer

The model is symmetrical, so you can just print two if you need both left and right mounts. Mirror flip one of them if you want the same ‘finish’ on top/bottom

Please comment, rate the model and kindly post your makes for everyone to see!
Advice and requests are welcome!