Cults3D

Gadget

Replacement threaded insert for 80mm Centercaps

von RRhind · Gadget

0 Downloads

0 Likes

0 Makes

If you're here it's because you've sheared your center cap in half from overtorquing it. Because same.

This replacement part can be clipped into the aluminium section, and then i'd recommend using a soldering iron to melt the plastic down and stamp it, similar to the OE part. At minimum put a bit of silicon or glue into it to keep everything together.

This part was based on center caps from Rotiform LSRs, but might suit other similar center caps.

centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap centercap rotiform bbs 80mm threaded center cap

Kategorie

Gadget

Quelle

Cults3D

Veröffentlicht

28.03.2026

Aktualisiert

28.03.2026

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat

STL

Material

PLA

Nachbearbeitung

Kleben

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

Replacement threaded insert for 80mm Centercaps

Ähnliche Modelle

Zur Sammlung hinzufügen