Thingiverse
Replicator 2 Bed Carriage
by Gringoling
9
Downloads
6
Likes
0
Makes
ADVANCED PROJECT!!!
DO NOT EXPECT ANYTHING TO FIT RIGHT IN PLACE!!!
IT TAKES A LOT OF PATIENCE AND ADJUSTMENT TO GET IT RIGHT!!!!
YOU MIGHT NEED TO DESIGN OWN STUFF AS YOU GO!!!
I HAVE A RAMPS REPLICATOR 2 WITH SIMPLE MECH ENDSTOPS, YOU MIGHT NEED TO FIND A SOLUTION FOR YOUR OWN!!
I HAVE LM8 BEARINGS AND 8MM SMOOTH RODS FOR THE Z WITH A PIECE OF A 10MM STEEL TUBE AT EACH END TO MAKE THEM FIT INTO THE ORIGINAL FRAME!
i had a broken Suitcase and cut its Square metal tube Grip into pieces to make myself a rigid Buildplate
It was 16.5x16.5mm tube with c.a 1m Lenght in total.
I designed the Parts "on the go", means i printed a part, put it in place and took measures of what i need for the next one :)
You also need some Screws and a 10mm Rod/Tube
SOME PARTS MIGHT CHANGE! STAY TUNED :)
DO NOT EXPECT ANYTHING TO FIT RIGHT IN PLACE!!!
IT TAKES A LOT OF PATIENCE AND ADJUSTMENT TO GET IT RIGHT!!!!
YOU MIGHT NEED TO DESIGN OWN STUFF AS YOU GO!!!
I HAVE A RAMPS REPLICATOR 2 WITH SIMPLE MECH ENDSTOPS, YOU MIGHT NEED TO FIND A SOLUTION FOR YOUR OWN!!
I HAVE LM8 BEARINGS AND 8MM SMOOTH RODS FOR THE Z WITH A PIECE OF A 10MM STEEL TUBE AT EACH END TO MAKE THEM FIT INTO THE ORIGINAL FRAME!
i had a broken Suitcase and cut its Square metal tube Grip into pieces to make myself a rigid Buildplate
It was 16.5x16.5mm tube with c.a 1m Lenght in total.
I designed the Parts "on the go", means i printed a part, put it in place and took measures of what i need for the next one :)
You also need some Screws and a 10mm Rod/Tube
SOME PARTS MIGHT CHANGE! STAY TUNED :)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
