Thingiverse
Replicator 2 Corner Wide Angle Pi Camera Mount
10
Downloads
6
Likes
0
Makes
Remixed from https://www.thingiverse.com/thing:2258287
I wanted a mount for my Replicator 2, and wanted to build the angles into the mount itself. The original mount has been given a 5 degree down angle and a slight 5 degree turn towards the front of the machine (if mounted on the front left side, mirror if you want it on the right) in order to center the bed a little better.
I also thinned out the front of the case front to give a bit more clearance. I also punched a square hole in the back of the mount to allow a little airflow, reduce material.
Take care when mounting to be sure the gantry doesn't hit the lens.
I wanted a mount for my Replicator 2, and wanted to build the angles into the mount itself. The original mount has been given a 5 degree down angle and a slight 5 degree turn towards the front of the machine (if mounted on the front left side, mirror if you want it on the right) in order to center the bed a little better.
I also thinned out the front of the case front to give a bit more clearance. I also punched a square hole in the back of the mount to allow a little airflow, reduce material.
Take care when mounting to be sure the gantry doesn't hit the lens.
AnatomicFlack also publishes on
16 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
