Thingiverse
Replicator 2X Dial Indicator Holder for Mitutoyo
von MILKA
60
Downloads
35
Likes
0
Makes
- Remix from furicks - http://www.thingiverse.com/thing:81430. I have narrow the slot for the Mitutoyo dial indicator - Model: 2046S. Now the slot is tightly fitted without any support for the stem.
The L shape was made precisely by furicks. But lacking of photos to illustrated the mounting location.
Personally, I found that the holder has the best orientation as it is the closest to the extruder. Hence, the levelling could cover most of the area of your platform.
Nonetheless, the mounting has to be side way and watch over from the side while pressing the jog mode.
Be very careful not to travel the -Y axis too much towards the front as the probe will extend, knock the dial and caught under the heated bed.
The L shape was made precisely by furicks. But lacking of photos to illustrated the mounting location.
Personally, I found that the holder has the best orientation as it is the closest to the extruder. Hence, the levelling could cover most of the area of your platform.
Nonetheless, the mounting has to be side way and watch over from the side while pressing the jog mode.
Be very careful not to travel the -Y axis too much towards the front as the probe will extend, knock the dial and caught under the heated bed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!