Thingiverse
ReplicatorG profiles for Sailfish
by whpthomas
198
Downloads
127
Likes
1
Makes
UPDATED Aug, 14 2013
These are my updated profiles for printing with the Replicator 2 using the latest release of ReplicatorG 40 (r16) and Sailfish.
My guide to installing the Sailfish firmware on the Replicator 2/2X can be found here: [thingiverse.com/thing:61022]( http://www.thingiverse.com/thing:61022 "Acceleration Test Shape")
Improvements include:
- A 5D pre-prime sequence with slow wipe
- 100 micron profile with 200 micron first layer
- Improved dwindle setting to reduce stringing
- 340 micro zero fill profile for printing stretchlet bracelets
- Material profiles match - use PLA for PLA and ABS for ABS, the only difference is the packing density
- An improved zipper
These are my updated profiles for printing with the Replicator 2 using the latest release of ReplicatorG 40 (r16) and Sailfish.
My guide to installing the Sailfish firmware on the Replicator 2/2X can be found here: [thingiverse.com/thing:61022]( http://www.thingiverse.com/thing:61022 "Acceleration Test Shape")
Improvements include:
- A 5D pre-prime sequence with slow wipe
- 100 micron profile with 200 micron first layer
- Improved dwindle setting to reduce stringing
- 340 micro zero fill profile for printing stretchlet bracelets
- Material profiles match - use PLA for PLA and ABS for ABS, the only difference is the packing density
- An improved zipper
whpthomas also publishes on
6 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
