RepRack 2020 Extrusion Mount

Remix of https://www.printables.com/model/129024-reprack-open-source-spool-holder-and-storage-syste

Mount your RepRack to 2020 extrusion troughs with this cleat. For each cleat, you need 2 M5x18 bolt and 2 M5 hammer nuts. If tapping and threading the extrusion, you'll likely need longer bolts.

I've found a little bit of warping is actually a good thing for this model. The mount applies a constant force on the bolt, eliminating the need for lock washers.

There are also some 3.5mm holes near the top of the model. I originally was going to add some more support to the mount, but it wasn't necessary. I left the holes in the model because "why not?".



BOM (per mount):

2 x M5x18 bolt

2 x M5 Hammer Nut