Thingiverse
RepRap Full Graphic Smart Controller Enclosure
von jmdunlap01
42
Downloads
30
Likes
0
Makes
This is a low profile enclosure I modeled for the [RepRap Full Graphics Smart Controller](https://www.amazon.com/HiLetgo-Printer-Controller-Display-Arduino/dp/B07X378P8X/ref=sr_1_4?crid=19B36ATH0R0DU&dchild=1&keywords=reprap+full+graphics+smart+controller&qid=1615223823&sprefix=reprap+full%2Caps%2C179&sr=8-4#customerReviews). It is designed to mount to a vertical surface, in my specific case a table for my [MPCNC](https://www.v1engineering.com/).
It will print without supports if you orient the face to the print bed. Once it is mounted the case is very rigid.
Fasteners used:
- [Heat Set Threaded Inserts][1] (M3 6mm used)
- [M3 Screws][2] (M3 8mm used)
- [#8 Wood Screws][3] (For mounting, any #8 screw would work)
[1]: https://www.amazon.com/Hilitchi-250-Pcs-Threaded-Embedment-Assortment/dp/B0784VYCYY/ref=sr_1_1_sspa?dchild=1&keywords=m3+6mm+hs+thread+insert&qid=1615223071&sr=8-1-spons&psc=1&spLa=ZW5jcnlwdGVkUXVhbGlmaWVyPUEzR1o2VEtYWU5GOEc4JmVuY3J5cHRlZElkPUEwMzg5MTcwMUtVO
It will print without supports if you orient the face to the print bed. Once it is mounted the case is very rigid.
Fasteners used:
- [Heat Set Threaded Inserts][1] (M3 6mm used)
- [M3 Screws][2] (M3 8mm used)
- [#8 Wood Screws][3] (For mounting, any #8 screw would work)
[1]: https://www.amazon.com/Hilitchi-250-Pcs-Threaded-Embedment-Assortment/dp/B0784VYCYY/ref=sr_1_1_sspa?dchild=1&keywords=m3+6mm+hs+thread+insert&qid=1615223071&sr=8-1-spons&psc=1&spLa=ZW5jcnlwdGVkUXVhbGlmaWVyPUEzR1o2VEtYWU5GOEc4JmVuY3J5cHRlZElkPUEwMzg5MTcwMUtVO
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
