RepRapMicroLite

May get some photo's up on it later.

This is my first full design on my prusa-reprap, as well as my first on my CAD program. Works great! Thought about putting a switch on it, yet wanted it small and out of the way. So, this is the end result.

Did not know the springiness of the PLA plastic when i designed the clips. They printed great yet too tight to snap on my 5/16 threaded rod i made them for. So, i just powered up the old hair blow dryer and in about 2 minutes it was snapped on, then off again and a little tiny squeeze to make it a snap on and it works great. Just don't expect PLA to have any spring on an item this small. Hard stuff! ABS plastic may be different, don't know, never used it ... Yet!!

Print it slow, mine on 30mm/s, and it should do well for you.

It uses 3 tiny LED bulbs "T10, W5W, 168, 194, 7SMD" any of those should work i think. 12V White LED's. Mine i found on ebay 6 bucks for a ten pack. Shipping was USA, may find them China cheaper if you want t