Thingiverse
Resin Curing Chamber
por eneref
198
Descargas
177
Likes
3
Makes
Two models (only one shown) for a resin curing chamber. Both of which have an indentation designed for UV LED strips (the ones I modeled after were the Deep Dream 5M UV LED strip from Amazon : https://www.amazon.com/gp/product/B01C2NQWIQ ).
Given the nature of UV light, I tend to use the model with a spiral indentation on the inside, printed with black/opaque filament. The spiral is the proper length to have the strip start at the bottom, go back and forth twice, and then spiral up the inside to the top with the power cable popping through the divet at the top of the container. I recommend a lid of some kind. This model is perfect for dry-curing UV resin (or lacquer). It's about 126.6mm in diameter internally (131mm diameter externally) and 175mm tall.
It will fit on a Prusa/Ender 3/etc -- smallish bed.
The other model has the spiral going up the OUTSIDE of the container, intending for you to print in translucent filament, point the UV lights inward, and tape them onto t
Given the nature of UV light, I tend to use the model with a spiral indentation on the inside, printed with black/opaque filament. The spiral is the proper length to have the strip start at the bottom, go back and forth twice, and then spiral up the inside to the top with the power cable popping through the divet at the top of the container. I recommend a lid of some kind. This model is perfect for dry-curing UV resin (or lacquer). It's about 126.6mm in diameter internally (131mm diameter externally) and 175mm tall.
It will fit on a Prusa/Ender 3/etc -- smallish bed.
The other model has the spiral going up the OUTSIDE of the container, intending for you to print in translucent filament, point the UV lights inward, and tape them onto t
eneref también publica en
1 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
