Resin Washer (Parametric)

Needed a small box in which I could clean small objects with IPA without making a huge mess. Ideal for resin minis and other small objects. The print also uses less than 100g of filament if you use the included print profile! I printed the gasket out of TPU (the print profile only has PLA), the box still isn't watertight but I was worried the PLA might be too stiff. I haven't tried the gasket in PLA but there should be no issues. The gasket should be solid if you do use TPU. I used a couple of drops of glue to hold the gasket and handles in place. Press fitting the gasket and handles works but I'd rather have a more sturdier solution. The way I used this is by putting the objects inside the tray and just lifting it up and down in the IPA. You can use the edge to support the tray on the box to let the objects in the tray dry in the air (seen in the picture). You can also take the tray out and put it on the lid in the indent, it will ‘float’ on top of it. I'd suggest usin