Thingiverse
RESIST hitch cover
door PunyPaladin
5
Downloads
9
Likes
0
Makes
This is a hitch cover for 1-1/4" receivers.
It has spring tabs on the side that fit snugly in my Draw-Tite receiver.
I used PrusaSlicer's 2-color printing. Print the first few layers in one color, then change filament to a contrasting color for the remainder of the print. No MMU necessary!
It has spring tabs on the side that fit snugly in my Draw-Tite receiver.
I used PrusaSlicer's 2-color printing. Print the first few layers in one color, then change filament to a contrasting color for the remainder of the print. No MMU necessary!
PunyPaladin publiceert ook op
14 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!