Thingiverse
Resist Stamp
von MinnesotaCowboy
0
Downloads
1
Likes
0
Makes
Based off of other like images for a campaign to resist changes that would negatively impact the National Parks in the United States. There are a total of three parts for this stamp.
The stamp itself: Resist Stamp.stl which is to be printed using a flexible filament (TPU)
The stamp holder and cover: Stamp Holder for Resist which is printed with standard PLA.
I super glued the TPU to the PLA but hot glue should also work as this is non structural.
Then any ink pad should work but I purchased and used the ones found at: https://www.amazon.com/dp/B01CKXUCNE
The stamp itself: Resist Stamp.stl which is to be printed using a flexible filament (TPU)
The stamp holder and cover: Stamp Holder for Resist which is printed with standard PLA.
I super glued the TPU to the PLA but hot glue should also work as this is non structural.
Then any ink pad should work but I purchased and used the ones found at: https://www.amazon.com/dp/B01CKXUCNE
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
