Thingiverse
Resurrection Ship
von By_Your_Command
16
Downloads
24
Likes
0
Makes
This is a version of the Resurrection Ship from Battlestar Galactica. I skipped the long antenna as this would be way to fragile.
As I can't make my printer to stop stringing, this ship has to be printed im many single files, which need to be glued together.
You need:
1x Spine Upper
1x Spine Lower (this part needs to be printed with support!)
3x Spike Keyhole (which will give six "spikes", three on either side of the keyhole)
18x Spike closed (they go all on the upper side of the ship, look at the pictures)
28x Spike open (lower side of the ship, on top of engine section and to the front.)
As I can't make my printer to stop stringing, this ship has to be printed im many single files, which need to be glued together.
You need:
1x Spine Upper
1x Spine Lower (this part needs to be printed with support!)
3x Spike Keyhole (which will give six "spikes", three on either side of the keyhole)
18x Spike closed (they go all on the upper side of the ship, look at the pictures)
28x Spike open (lower side of the ship, on top of engine section and to the front.)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
