Thingiverse
Retaining Brackets for Zarges Box
von Syltet0y
0
Downloads
1
Likes
0
Makes
Simple retaining brackets for zarges boxes.
I believe most of the corner radiuses are the same across the product line.
You can use two of the liftlock brackets and two of the standard brackets.
Or you can use four of the standard brackets.
Will work with any 35mm radius rounded edge box.
I suggest you print these with high wall thickness, and a lot of infill.
The holes are designed to be used with 12mm washers.
I believe most of the corner radiuses are the same across the product line.
You can use two of the liftlock brackets and two of the standard brackets.
Or you can use four of the standard brackets.
Will work with any 35mm radius rounded edge box.
I suggest you print these with high wall thickness, and a lot of infill.
The holes are designed to be used with 12mm washers.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!