Thingiverse
Retractometer Cr-10s Pro
door Ernstlustig
8
Downloads
8
Likes
0
Makes
This is a visualizer for retract but also for flow of Filament - by the way it cleans and guides the filament.
It was build to find out if the retract setting from the slicer was correct in reality.
I like to get a feeling of whats going on while printing - now i can see the retract very good.
...if you turn the pointer a bit to the right you will see the flow. If the waving cat effect disturbs you - you can lock the Pointer horizontal - it will still guide and clean the filament.
you will need one M4 screw as axis for the pointer and a little peace of a sponge - cut the sponge half but not all the way leave about 5mm uncutted, the little clips can slide to set your retract marks.
its a work in progress - a lot of room to make it better...enjoy
It was build to find out if the retract setting from the slicer was correct in reality.
I like to get a feeling of whats going on while printing - now i can see the retract very good.
...if you turn the pointer a bit to the right you will see the flow. If the waving cat effect disturbs you - you can lock the Pointer horizontal - it will still guide and clean the filament.
you will need one M4 screw as axis for the pointer and a little peace of a sponge - cut the sponge half but not all the way leave about 5mm uncutted, the little clips can slide to set your retract marks.
its a work in progress - a lot of room to make it better...enjoy
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
