MakerWorld
Electronics
Zum Modell
Retro Magsafe Charging Stand
6
Downloads
4
Likes
2
Makes
FOR HORIZONTAL MOUNTING. DOES NOT ACCOMMODATE VERTICAL MOUNTING. I wanted to make a Magsafe charging stand that was inspired by the googie, space-age style TV's of the sixties. This was the result. I used a .08mm layer height to avoid needing very much support, but you can change that to fit what you want. The USBC end of the cable fits through the stem of the stand and out through the groove on the bottom. The stand also stays in place well when you take the phone off by pulling it down to get it off, but i still decided to cut a circle of silicone for the base. I used this cutter. This is the magsafe charger I used.This is the silicone used.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
