Thingiverse
Retro Pi case for Raspberry pi 3
von Air3lax
26
Downloads
14
Likes
0
Makes
A little case for Raspberry pi 3. There are so much square cases -here you get a round housing!
Parts are in the right orientation. Print no bottom Layer for the surface effect.
Both Parts: 2 Perimeters; 50% Infill; 0.3 Layer height; Honeycomb Infill
A bit less Infill may also work, especially for the bottom plate.
Parts are in the right orientation. Print no bottom Layer for the surface effect.
Both Parts: 2 Perimeters; 50% Infill; 0.3 Layer height; Honeycomb Infill
A bit less Infill may also work, especially for the bottom plate.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
