Retropie Switch

I have uploaded the step,igus, and sldprt files for the main case. I don't guarantee that the hole locations for the screen are perfect, I had to open up the holes a bit to match the hole pattern on my screen, I believe this is an issue with my printer though. The joycons will slide right in and fit snug. any pi case that mounts through the bottom of the case should work with the main case, the mounting holes are the same as the Pi. This is a work in progress, and feel free to modify. I have only tested the battery life to ~1:15min, but theoretically it should go further. I recommend a better lipo charger if you know of one, these cheap chinese ones are not great. This setup will power the pi up to 3A, using my charge doctor it pulls ~2.5A. Make sure your battery can support this, and have a charger than can support charging and the Pi together. It is a UPS, so you can plug and unplug the pi without it powering down. I don't have a shutdown button yet, the case has one I just haven't s