Thingiverse
Reuseable and customizable Icecube Mold
door acer625
4
Downloads
2
Likes
1
Makes
Design for a reuseable and customizable Icecube Tray.
To make my own stamps, I loaded both the basic cube and the model to be replicated in Blender and used the Modifier-Boolean-Difference tool to get a proper imprint.
Important for making:
For good resolution best print the cubes on their side. For top-prints use Basic_cube_top_print. It has a larger hole due to higher tolerance in xy-plane.
!!!!! Print the stamps with high infill, or fill with water. Otherwise they will be pushed upward from the silicone. !!!!!
Alternatively you can manually push the stamps down until the silicone started hardening (usually about 30 mins)
For best results coat model and stamps with Anti-Adherent.
To make my own stamps, I loaded both the basic cube and the model to be replicated in Blender and used the Modifier-Boolean-Difference tool to get a proper imprint.
Important for making:
For good resolution best print the cubes on their side. For top-prints use Basic_cube_top_print. It has a larger hole due to higher tolerance in xy-plane.
!!!!! Print the stamps with high infill, or fill with water. Otherwise they will be pushed upward from the silicone. !!!!!
Alternatively you can manually push the stamps down until the silicone started hardening (usually about 30 mins)
For best results coat model and stamps with Anti-Adherent.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
