Revan Saber Endcap

I noticed when I printed the Revan saber, the bottom end came out completely flat, as you would expect being on the build plate. Try as I might, I could not remove anything to get to the bottom cap design, although I could see it was there. My solution was to design a small endcap to glue onto the bottom. This was just something I did quick, and does not match what the actual end of the saber looks like, however, it does tidy up the look of the saber.

Note: The pics of the single part on the build plate are of an earlier version, and the pic of the saber end is the final design. Additions were a small lip around the piece, and adding more sides to the circle for smoothness. It does add 6mm to the length, if that is important.