Revised/fixed Movie Dalek model

I have remixed this model to fix the mesh a bit and changed a few tolerances. I also decided to make it larger as any smaller meant that the arms and eye-stalk were getting too small for a 0.4mm nozzle. If you want me to make any variants of this for resin printing, mesh fixes, electronics, etc. feel free to ask.



PRINT SETTINGS:
-------------------

I do not recommend printing the 'DalekMain_8.8cm model, that's more for specialised printing. You want All the other files, and a bit of superglue. Please excuse my terrible alignment job in the photo...

Information partly in regards to Creality Slicer settings.
- Layer Heights - 0.1mm for the arms/eye. 0.2mm for the body (it's a larger layer height in the picture).
- Supports - Yes for the arms/eye, and these are a difficulty. As for the main body, my Ender 3 v3 did struggle a bit with the overhanging edges that still remain in these models but with better cooling you might have much better results.
Note: Beware of using overhang optim