Thingiverse
Revised Schwibbogen
door SvenS
104
Downloads
68
Likes
1
Makes
I improved on the small version of the Schwibbogen Smithy:
- cleaned up some unnecessary paths
- widened some parts that were too tiny
- added a base ala http://www.thingiverse.com/thing:17240
- removed some parts I didn't know where to put when assembling (may add them in a v2 when I can identify them ;))
I also changed everything to 3mm plywood and put it on a 400x300 sheet (the material available at my local FabLab).
Paths to cut have a width of 0.01mm, paths to engrave are 0.5mm.
- cleaned up some unnecessary paths
- widened some parts that were too tiny
- added a base ala http://www.thingiverse.com/thing:17240
- removed some parts I didn't know where to put when assembling (may add them in a v2 when I can identify them ;))
I also changed everything to 3mm plywood and put it on a 400x300 sheet (the material available at my local FabLab).
Paths to cut have a width of 0.01mm, paths to engrave are 0.5mm.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
