Thingiverse
Rework front end with induction mount
von ArgGrr
2
Downloads
0
Likes
0
Makes
I did a quick rework of the front section so I can mount my induction sensor.
I had it in another mount which was glued to the side, but this failed eventually. Now it is held in place firmly with zip ties.
My induction sensor is the typical 18mm one.
I had it in another mount which was glued to the side, but this failed eventually. Now it is held in place firmly with zip ties.
My induction sensor is the typical 18mm one.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!