Rey's Staff

I made a model of Rey's Staff after wanting to make her staff for a while before I had my printer. This whole model is based around a 21.5mm diameter pipe I had so when printing keep that in mind.

The model consists of 29 pieces, each piece has notched on the inside hole at the bottom of them to show which piece they are bar part 1 which has it in its top (these may be clearer to see on different printers but came out countable on mine).

Some of the pieces in the middle (mainly 11 through 16) can be omitted to lengthen to your needs and if you want to save on filament as these are slightly thicker than the pipe to gage spacing, each are a good guide for where to wrap each material after printing.

A good number of pieces need supports to print correctly but if printing vertically I would suggest that pieces 8, 10, 17, 18, 19, and 23 only have support touching the build plate

Piece 1 is the base piece (I think it's not always consistent in pictures which end is the top), so I