Thingiverse
RF433Analyser
von bobtidey
10
Downloads
4
Likes
0
Makes
This is a case for a RF 433MHz analyser.
It holds an ESP-12F module with attached electronics, a SSD1306 display, RX6 433Mhz receiver and a LIPO battery. Cut outs are included for a recharge point and a single button for control.
It is designed to measure signal strength to help asses coverage and facilitate capturing clean data from RF transmissions.
Code and description are at https://github.com/roberttidey/RF433Analyser
Construction details at Instructables. https://www.instructables.com/id/RF433Analyser/
It holds an ESP-12F module with attached electronics, a SSD1306 display, RX6 433Mhz receiver and a LIPO battery. Cut outs are included for a recharge point and a single button for control.
It is designed to measure signal strength to help asses coverage and facilitate capturing clean data from RF transmissions.
Code and description are at https://github.com/roberttidey/RF433Analyser
Construction details at Instructables. https://www.instructables.com/id/RF433Analyser/
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
