Thingiverse
RGB LED Strip - Remote Wall Mount
590
Downloads
444
Likes
0
Makes
I designed and 3D printed this remote control holder for RGB-LED strips a few years ago and mounted it in the shed.
I printed it in PLA and due to the temperature fluctuation it slightly warped over the years, but it's still holding up and doing it's job.(as you can see in the pictures)
If I were to print it again I'd use another material though. At least for the shed.
### [MY OTHER DESIGNS](http://www.thingiverse.com/friedsemiconductors/designs/)
I printed it in PLA and due to the temperature fluctuation it slightly warped over the years, but it's still holding up and doing it's job.(as you can see in the pictures)
If I were to print it again I'd use another material though. At least for the shed.
### [MY OTHER DESIGNS](http://www.thingiverse.com/friedsemiconductors/designs/)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!