Thingiverse
RGB Projector Lamp
von JobSmolders
170
Downloads
200
Likes
1
Makes
RGB Projector Lamp
This is the RGB Projector Lamp.
The idea is to project figures on to the sealing of your room. These projections are in Red, Green and Blue light. The round disk turns once in a while so the projections also move. To make more effects an Arduino also switches the LEDs on or off. I tried to make some videos and posted them on youtube: https://www.youtube.com/watch?v=gLcDPI3Z4Io. Here you will get an idea how this RGB Lamp behaves :-) . But I have speeded it up in the Arduino just for the video.
This RGB Projector Lamp has an RED LED, Green LED, and Blue LED, stepper driver, 28byj-48 stepper and an Arduino Nano. There are no screws or bolts needed. Everything just clicks together. (Also needed is a transistor like TIP20 and some resistors)
I also included an Arduino Script I use myself at the moment.
Please see pictures for a wiring diagram. The LEDs I used are 1W each. Each LED is thermo glued to a heat sink. The Arduino gets its power through the usb port
At
This is the RGB Projector Lamp.
The idea is to project figures on to the sealing of your room. These projections are in Red, Green and Blue light. The round disk turns once in a while so the projections also move. To make more effects an Arduino also switches the LEDs on or off. I tried to make some videos and posted them on youtube: https://www.youtube.com/watch?v=gLcDPI3Z4Io. Here you will get an idea how this RGB Lamp behaves :-) . But I have speeded it up in the Arduino just for the video.
This RGB Projector Lamp has an RED LED, Green LED, and Blue LED, stepper driver, 28byj-48 stepper and an Arduino Nano. There are no screws or bolts needed. Everything just clicks together. (Also needed is a transistor like TIP20 and some resistors)
I also included an Arduino Script I use myself at the moment.
Please see pictures for a wiring diagram. The LEDs I used are 1W each. Each LED is thermo glued to a heat sink. The Arduino gets its power through the usb port
At
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
