Thingiverse
Ribbed Potentiometer Knob
von 3DSkuzee
3
Downloads
4
Likes
0
Makes
knob is 24.4mm diameter x 17mm tall.
hole is 6mm diameter x 11mm deep.
Should be a nice press fit onto a 1/4" ribbed potentiometer.
You can apply heat to the knob/pot shaft to shape the plastic perfectly, or use horizontal offset to adjust fitment.
hole is 6mm diameter x 11mm deep.
Should be a nice press fit onto a 1/4" ribbed potentiometer.
You can apply heat to the knob/pot shaft to shape the plastic perfectly, or use horizontal offset to adjust fitment.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
