Ride hight gauge

Figured i might as well make a ride hight gauge as well.
Here is a link to the camber gauge as well https://www.thingiverse.com/thing:3025081
This gauge spans from 4mm to 82mm so it should be able to acomodate everything from a on road racer to something big lika an xmaxx.

The only things marked up is min (4mm) and max (82mm) and everything in between is just steps of 1mm increments and every fifth marked a bit longer.

You will need 1 m3 bolt with locknut and washers as well as a m4 with a wingnut (to tighten easier) and washers.

No need for glue but if you dont feel that the pins and screws if sufficient you might want to consider low heat hotglue at a few spots, altho i dont think it will be necessary.


Update: increased size on the text, increased depth on the gaugemarkings, increased diameter on pinholes by 0.2mm.
It should be easier to print and get it easier to read now.
Also the gauge part (red in pictures) is possible to change even if you glue the outer parts