Riden Power Supply Workbench Mount

This is a workbench/general purpose mount for Riden RD series DC power supplies. These cheap power supplies are incredibly power dense and very useful for hobby electronics projects. Normally these are installed into an enclosure or panel with an AC/DC power supply to feed them 70V, but I needed to mount a few to a tabletop.

These use minimal filament, can be printed without supports, and are flat on the bottom so you can use VHB to mount them. I may upload a version later with screw holes for a more permanent solution, but VHB has worked very well for me.

The "face" of the mount (where the power supply slides in) should be touching the build plate to print without supports.