Thingiverse
Hobby
Zum Modell
Rifle Scope Throw Levers
583
Downloads
302
Likes
2
Makes
Needs an M3x10mm SHCS and an M3 x 5mm OD x 3mm long brass embedding nut. Use a soldering iron to install the embedding nut and it's ready to use.
Each throw lever is 10mm wide and model specific because I have interior diameter bosses to fit in the scope adjusting ring gripping cuts. This way they will not spin on the scope.
I have files for the following scopes:
Vortex Strike Eagle 1-8x24
Vortex Diamondback Tactical FFP 4-16x44
Vortex Viper PST FFP 6-24x50Gen1
Primary Arms FFP 4-14x44
Nikon M-Tactical 1-4x24
Each throw lever is 10mm wide and model specific because I have interior diameter bosses to fit in the scope adjusting ring gripping cuts. This way they will not spin on the scope.
I have files for the following scopes:
Vortex Strike Eagle 1-8x24
Vortex Diamondback Tactical FFP 4-16x44
Vortex Viper PST FFP 6-24x50Gen1
Primary Arms FFP 4-14x44
Nikon M-Tactical 1-4x24
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
