Right Angle 1/2in Pipe Hanger

I created this as a way to secure a vertical water line under my sink. This could be attached in any orientation that works for your needs. The current diameter is made for ½in PEX or copper water lines, and the size of the ‘arm’ is specific to my application. The screw holes were sized for #6 screws. Using the .stl file you can adjust the sizes to your needs. The pipe will slip into the half circle just like any commercially available hanger, so there is no need to attach before adding fittings. I did it after the fact in the photo I posted, so it should work for you as well.This was printed using Inland PETG+ with some modified settings of the Bambu .2 Strength preset. While it may be a bit overbuilt with those settings, I've used them in the past for shelf brackets and I wanted this piece to be secure under my sink. I printed one on it's side for maximum bracket strength, and one laying flat (like how it was installed). While I didn't test both of them on the pipe, they