RigidBot controller board (RigidBoard) side mount housing

Photos of finished build here: http://www.thingiverse.com/make:205396

Enclosure for the RigidBot original controller board (RigidBoard).
This differs from the original housing in that:
1. It is vastly better ventilated - no fan needed.
2. There is no risk of filament pieces or knocked-off prints hitting the board.

This enclosure is meant to be mounted vertically in one of the outside corners - upper left rear (version 3) or lower left rear (version 4) is recommended, but other places might suit you better depending on cable routing and power supply placement.

Prints in two parts, base and lid. Designed to be printed as is without support, raft or brim.

Even if using 100% infill (which is overkill), the total weight should be only around 70g (version 3), 85g (version 4), depending on material.

**Update 2016-01-18: Version 4**
* Changed position from upper to lower part of frame for better cable management. Heated bed cable should not be a problem (measured with RB re