Thingiverse
Rigidbot Inductor sensor holder
por t0wer
37
Descargas
14
Likes
0
Makes
I couldn't use the other holders with an e3d not setup as z-lossless, as the probe wasn't long enough to reach the bed.
The probe should just thread right in without the use of screws, just put the 2 nuts together and turn the probe from the 2 nuts. Just gripping the probe with pliers you might damage the housing.
The fit is VERY tight.
The probe should just thread right in without the use of screws, just put the 2 nuts together and turn the probe from the 2 nuts. Just gripping the probe with pliers you might damage the housing.
The fit is VERY tight.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
