Thingiverse
Rigidbot Part Fan Mount
door DylanWave
3
Downloads
4
Likes
0
Makes
This fan mount is designed to work with this Sparkfun blower: https://www.sparkfun.com/products/11270
It may be overpowered as hell, but with 2 of them in series connected to 12V, I get amazing results from my prints. The fans will reduce the size of your X axis, so it might be best to start with one, even if you have dual extruders. I'm working on a version that will go over the X rods.
Both the mounts and the nozzle can be printed without supports, and if you use a desk fan for cooling you'll get decent overhangs. The nozzle should snap into the mount (may require a bit of effort) and the fan itself slides into the mount and can be secured with zip ties or screws. The mount screws onto the existing screws on the side of the extruder.
It may be overpowered as hell, but with 2 of them in series connected to 12V, I get amazing results from my prints. The fans will reduce the size of your X axis, so it might be best to start with one, even if you have dual extruders. I'm working on a version that will go over the X rods.
Both the mounts and the nozzle can be printed without supports, and if you use a desk fan for cooling you'll get decent overhangs. The nozzle should snap into the mount (may require a bit of effort) and the fan itself slides into the mount and can be secured with zip ties or screws. The mount screws onto the existing screws on the side of the extruder.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
