Thingiverse
RigidBot Z-Limit Screw
von tchotchke
31
Downloads
10
Likes
0
Makes
A variation of the [RigidBot Z-stop Adjustment Screw](http://www.thingiverse.com/thing:362662) by [mikedifilippo](http://www.thingiverse.com/mikedifilippo/designs)
This one uses a short 5mm x 8mm flathead screw and 4mm x 8mm button head screw. The z-limit switch needs to be rotated by about 45 degrees. The range of adjustment of this design is very limited, only a few millimeters, but works with my setup, which uses a 1/8" polycarbonate plate on top of the build plate. I'm not sure how it would work if printing directly on the build plate.
This one uses a short 5mm x 8mm flathead screw and 4mm x 8mm button head screw. The z-limit switch needs to be rotated by about 45 degrees. The range of adjustment of this design is very limited, only a few millimeters, but works with my setup, which uses a 1/8" polycarbonate plate on top of the build plate. I'm not sure how it would work if printing directly on the build plate.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
