Thingiverse
Ring for Flex Radio FlexControl
door FoxMike
2
Downloads
2
Likes
0
Makes
This is a replacement ring for the FlexControl USB VFO knob for the FlexRadio 6000/8000/Aurora series radios.
It is installed in place of the two factory O-rings. It needs to be printed out of TPU so it will stretch over the aluminum knob. Remove the knob from the FlexControl to make installation much easier/safer. It is removed with a 1.5mm hex grub screw. The replacement ring has a hole you should line up with the grub screw so it is easy to tighten the knob back on after the ring is installed.
It is installed in place of the two factory O-rings. It needs to be printed out of TPU so it will stretch over the aluminum knob. Remove the knob from the FlexControl to make installation much easier/safer. It is removed with a 1.5mm hex grub screw. The replacement ring has a hole you should line up with the grub screw so it is easy to tighten the knob back on after the ring is installed.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!