Thingiverse
Ring Lamp Dual V2 (Customizable)
door geit_de
813
Downloads
705
Likes
2
Makes
A little ring lamp with 330mm or 200mm diameter. You need a printer with around 220x220mm build plate to be able
There is a V1 of this model: https://www.thingiverse.com/thing:4817409 (Stargate)
There is a V3 of this model: https://www.thingiverse.com/thing:4904677 (Halo)
Here is a link were you can see the new version in action. The mode running is "Race".
Ring Lamp V2 Race mode
Key Features:
When designing this I had some key features in mind:
° simple and clean print
° avoid the led strips glue tape on the back at all cost.
° add a simple compartment for the electronics.
° wire management
° easy to print.
° no flimsy pegs to mount, which fail printing or break away later on.
Requirements:
1x 5V power supply
1x Power Connector
1x Switch
1x LED strip. (60 pixel/m or more)
WARNING! You need a LED strip without a rubber dome. Just the plain flexible PCB with the LEDs and resistors soldered on.
I used a 60 pixel/mm strip and ended up using 118 LEDs
There is a V1 of this model: https://www.thingiverse.com/thing:4817409 (Stargate)
There is a V3 of this model: https://www.thingiverse.com/thing:4904677 (Halo)
Here is a link were you can see the new version in action. The mode running is "Race".
Ring Lamp V2 Race mode
Key Features:
When designing this I had some key features in mind:
° simple and clean print
° avoid the led strips glue tape on the back at all cost.
° add a simple compartment for the electronics.
° wire management
° easy to print.
° no flimsy pegs to mount, which fail printing or break away later on.
Requirements:
1x 5V power supply
1x Power Connector
1x Switch
1x LED strip. (60 pixel/m or more)
WARNING! You need a LED strip without a rubber dome. Just the plain flexible PCB with the LEDs and resistors soldered on.
I used a 60 pixel/mm strip and ended up using 118 LEDs
geit_de publiceert ook op
79 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
