Back
Ring Puzzle challenge – 3D printable model from MakerWorld MakerWorld
Puzzles

Ring Puzzle challenge

7 Downloads
3 Likes
3 Makes
Download Model
A simple puzzle that may pose a larger challenge than expected. but i believe you guys and gals can solve it.You will need a length of string (approx 12") that will not pull through the small knobs once knotted. There are two methods to challenge youself with this puzzle: Tie the ring on to the puzzle when assebling taking care to ensure the string goes over and under the ring and string crossing as shown in the picture. Then attempt to remove the ring. ORassemble the string to the base plat
Category
Puzzles
Source
MakerWorld
Published
18.01.2024
Updated
03.03.2026
Comments
0

Bewertung

Noch keine Bewertungen

Comments

No comments yet – be the first!
More Puzzles Models All MakerWorld Models More by byronbuilds

Similar Models

6 Suggestions

Add to Collection