Ristretto Keyboard Case

This is a modular case for the Ristretto keyboard by Fruitykeeb. It prints on 6 pieces and fits on printers such as Ender 3 or Ender 5 or similarly sized print bed. The print bed on an Ender 3/5 is 220x220x250mm. The case is designed to incorporate the switch plate and the bottom plate.

I printed each piece right side up. This meant a lot more supports being printed but it turned out far better than printing it with the top down, especially the three top pieces. The angle of the chamfer is such that it needs supports but doesn't print well if you print top down.

The two top and bottom pieces will fit together on the print bed.

I modeled two versions of the center piece. One is for use with a 1u key or encoder. The other is for a 1.25u up to 2u key.

The pieces snap fit together for the most part, but will also require 10mm standoffs between the top and bottom to keep it all together.