RJ4JP-01-08 Split Carrier

This is a remix of the RJMP-01-08 split bearing carrier by crashc0de. My intention is to make it fit the RJ4JP-01-08 bearings which are 1mm smaller in diameter.

26/06/17 - Uploaded another version which is 0.5mm shallower as there was a small gap at the edge of the bearing. I will leave the old version here too as it may depend on print tolerance. I would say to try this one first and if it doesn't fit all the way in with both halves assembled, try the other one.

25/06/17 - Uploaded a new version which should fit this time. Sorry if anyone wasted time with the previous version only to find it didn't fit. This version is very tight on my printed bearing but with a few insertions it fits perfectly!

Please post to comments if you have tried it and if it works for you. You will need to print 2 of them for a complete carrier.

Check out these 3D printer support groups on facebook for help with your settings or anything else printing related:
3D Printer Support Group
Official An