Thingiverse
Road Runner - MMU
by reddadsteve
170
Downloads
636
Likes
1
Makes
MMU version of Road Runner
Road Runner, a cartoon character in the Looney Tunes and Merrie Melodies series of short films produced by Warner Bros.
The model, as presented is 75mm tall.
This MMU model was derived from my non-MMU model (reworked for a clean MMU print)
Print instructions
Important: I used three perimeters for extra strength
I've included a Prusa Slicer 3MF file that I used for this print.
Individual STL parts are also included for other slicers.
Extra note: I used the PrusaSlicer .2mm speed defaults for my MK4/MMU3, except for the following changes:
1 - I used organic supports and set the overhang parameter to 30deg.
2 -Take your time removing the supports!
Be sure to check/set the purge amounts for the colors based on your filament brand. I was able to use the PrusaSlicer defaults without issue
Road Runner, a cartoon character in the Looney Tunes and Merrie Melodies series of short films produced by Warner Bros.
The model, as presented is 75mm tall.
This MMU model was derived from my non-MMU model (reworked for a clean MMU print)
Print instructions
Important: I used three perimeters for extra strength
I've included a Prusa Slicer 3MF file that I used for this print.
Individual STL parts are also included for other slicers.
Extra note: I used the PrusaSlicer .2mm speed defaults for my MK4/MMU3, except for the following changes:
1 - I used organic supports and set the overhang parameter to 30deg.
2 -Take your time removing the supports!
Be sure to check/set the purge amounts for the colors based on your filament brand. I was able to use the PrusaSlicer defaults without issue
reddadsteve also publishes on
840 additional models across 5 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
