Robo3D Cable Holder

I based this off of the design by keraynopoylos' "Cable bundle holder for Robo3D printer" which is at http://www.thingiverse.com/thing:162100

This accomplishes the same thing. When you remove the cover from the Robo3D printer the zip tie that holds the cable bundle above the extruder is removed and thus the cable bundle is now loose and has no support.

This mounts to the size of the X carriage motor (same side as the cable bundle) and is secured using an M3 bolt, flat washer and lock nut. I built this one instead of using keraynopoylos' holder because of a few reasons. 1) the hole for the cable bundle has been widened; 2) the base of this bundle is thicker and thus has less warping due to strain from the cable bundle; and 3) I've widened the hole that the M3 bolt will go into giving it a little more clearance.

v2 of this cable holder has a longer cable holder section to try to keep the cable vertical.

Designed using Tinkercad. Design is at https://tinkercad.com/things/496dp