Thingiverse
Robot heads
von Ingvarsson
37
Downloads
21
Likes
0
Makes
I made a couple of extra heads so i could tell my armor-bearers apart.
Came out ok in 0.16mm but i'd recommend to go as low as you can.
They might need shrinking by a couple of % to fit depending on your printer and base armorbearer etc.
Came out ok in 0.16mm but i'd recommend to go as low as you can.
They might need shrinking by a couple of % to fit depending on your printer and base armorbearer etc.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!