Slicer Discord
Robot Keychain with LEDs – 3D printable model from MakerWorld MakerWorld
Robotics

Robot Keychain with LEDs

6 Downloads
8 Likes
0 Makes
Go to Model
Hallo,ich habe hier ein Remix des sehr schönen Roboters nun mit LEDs in den Augen und Energie Rucksack.Benötigt werden 2x 3mm blink LEDS, ein Stück Nickel Streifen 4 mm und 2x AG13/LR44 Knopfzellen.Das Batteriefach hat zwei Seiten, eine bei der Nickel Streifen durch den Boden geht das ist Plus Seite, die andere Seite an der Nickel Streifen seitlich raus kommt in Minus, bitte beachten.Den Nickel Streifen am besten von unten durch ziehen und dann am Rand oben umbiegen. -------- Hello,I have here a remix of the very nice robot now with LEDs in the eyes and energy backpack.Needed are 2x 3mm blink LEDS, a piece of nickel strip 4 mm and 2x AG13/LR44 button cells.The battery compartment has two sides, one where the nickel strip goes through the bottom that is plus side, the other side where the nickel strip comes out sideways in minus, please note.It is best to pull the nickel strip through from below and then bend it over at the top edge.Translated with DeepL.com (free version)
Category
Robotics
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
Min. bed size
50 mm (Small)
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

Caleb_3D also publishes on

34 additional models across 3 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection