Robot Tank (YP100) electronics tray

I made this for my YP100 robot tank project. It provides ample room to mount electronics without lowering the ride height. It also reinforces the frame, and protects the motors from getting snagged on taller obstacles as they pass underneath.

Print as is, no supports or rotation required. It holds on to the front plate, and bolts to the side plates with 2@ M3-10 bolts. There are holes to fit both 30mm and 45mm board stacks for a variety of applications. Note the one shown in the photo is an older revision with only 30mm hole spacing (I had to drill that for my 45mm PDB).