Robox profile for Simplify3D 3.1.1

This is an experimental fff-Profile and the factory file of the little torture test for the Robox Quickfil head. I downloaded the stl file for the torture test on the Robox forum. Thanks to nebbian for publishing the stl file and to Simon for publishing the experimental Simplify3D profile.

Workflow: Gcode from Simplify3D is saved to a file on the host computer. In Automaker 3.0.0 I go to Settings (the coged wheel icon), then to Maintenance. There is a button to send and execute gcode. Select the file that was created by Simplify3D and Automaker sends it to the Robox and starts the print.

Retraction is switched off in this profile. The needle valves are not active during printing. The Robox is able to do fast travel moves and this helps preventing ooze for small prints.
If you want to use the needle valves during printing activate retraction and set it to 0,5 mm. A value of 0,5 mm tells the postprocessor to use the needle valves for ooze control. Other values for retraction than